护坡模盒生产的护坡预制件是用来防风、防水、堤坝保护作用的。护坡模盒分为实心护坡模盒、空心护坡模盒、拱形护坡模盒、现浇护坡钢模盒、护坡现浇模盒、阶梯护坡模盒、生态护坡模盒主要是是这几大类。
The prefabricated parts of slope protection produced by the slope protection mould box are used for windproof, waterproof and dam protection. The slope protection mold box can be divided into solid slope protection mold box, hollow slope protection mold box, arch slope protection mold box, cast-in-place slope protection steel mold box, slope protection cast-in-place mold box, ladder slope protection mold box and ecological slope protection mold box.

护坡模盒安装模具必须在断电情况下进行,禁止碰撞启动按钮、手柄和用脚踏在脚踏开关上.装好上下模具对中,调整好模具间隙,不允许单边偏离中心,确认固定好后模具再试压.
The installation mold of slope protection mold box must be carried out under the condition of power failure. It is forbidden to collide with the start button, handle and pedal on the foot switch. Install the upper and lower mold alignment, adjust the mold gap, and do not allow one side to deviate from the center. Press the mold again after confirming that it is fixed

我们在护坡模盒制作中,尽管定模型腔的光洁度打得很光,因型腔较深,仍出现粘在定模上的现象.所以在模具设计时,必须全面分析铸件的结构,熟悉压铸机的操作过程。
In the production of the slope protection die box, although the surface finish of the fixed mold cavity is very smooth, it still sticks to the fixed mold because of the deep cavity. Therefore, in the mold design, we must comprehensively analyze the casting structure and be familiar with the operation process of the die casting machine.

要了解压铸机及工艺参数得以调整的可能性,掌握在不同情况下的充填特性,并考虑模具加工的方法、钻眼和固定的形式后,才能设计出切合实际、满足生产要求的模具.。
It is necessary to adjust the decompressing casting machine and process parameters, master the filling characteristics under different conditions, and consider the mold processing method, drilling and fixing form, so as to design the mold which is practical and meet the production requirements.